Skip to main content

How To Make Adjustable Dc Voltage Regulator | LM317 IC Adjustable Power ...


How to make adjustable dc voltage regulator with LM317 IC adjustable power supply 0 to 30v very easy circuit at home only 20 rupees.
10k Ohm Potentiometer :- 
https://amzn.to/3fvRBkw

220 Ohm 1/4 Watt Resistor :- https://amzn.to/3yuM7PH
Other Electronics component :-  https://amzn.to/3fClfou
Labels:

Comments

Post a Comment

Popular posts from this blog

Clap On Off Switch Circuit Using Arduino

  Arduino Clap LED program #define MicAO 8 int ledPin = 13; int clap = 0; long detection_range_start = 0; long detection_range = 0; boolean status_lights = false; void setup() {   pinMode(MicAO, INPUT);   pinMode(ledPin,OUTPUT);   } void loop() { int status_MicAO = digitalRead(MicAO); if (status_MicAO == 0) { if (clap == 0) { detection_range_start = detection_range = millis(); clap++; } else if (clap > 0 && millis()-detection_range >= 50) { detection_range = millis(); clap++; } } if (millis()-detection_range_start >= 400) { if (clap == 2) { if (!status_lights) { status_lights = true; digitalWrite(ledPin, HIGH); } else if (status_lights) { status_lights = false; digitalWrite(ledPin, LOW); } } clap = 0; } }
Post a Comment
Read more

Bluetooth Robot Car Using Arduino Project Step By Step

Bluetooth Controlled Robot Car Using Arduino Bluetooth Controlled Robot Car Using Arduino Project using LM298n motor deriver and hc-05 bluetooth module step by step tutorial. Code Download :- Click Here Arduino bluetooth controller app Arduino bluetooth controller App
Post a Comment
Read more

IOT Based Water Level Indicator Project Using Esp32 And Ultrasonic Sensor

  Water Level Indicator Project Using ESP32   Water Level Indicator with Alarm on Tank Full.   IoT Wi-Fi smart water level indicator for tanks with mobile app control . 📟 OLED Display (0.96" I2C SSD1306)   OLED Pin         ESP32 Pin VCC                     3.3V GND                     GND SDA                    GPIO 21 SCL                      GPIO 22     🔔 BUZZER   Buzzer Pin        ESP32 Pin   +           GPIO 26 -            GND         Each LED connects to an ESP32 GPIO pin via a current-limiting resistor.   ...
Post a Comment
Read more